Just finish to assemble my Acrylic Pro Prusa i3(arduino+RAMPS), but the arduino is dead...only power led working...my pc don't see the arduino even as unknow device.
I have chose arduino + ramp elettronic because i've programmed variuos model of arduino, so i'm experienced enough to say that is dead...no signal from or to the USB.
I've tested all the other elettronic with an old arduino and a firmware that i wrote just to move the motor and seem good (i haven't tried to heat the bed and the hotend and the lcd because i didin't find a connection diagram online)
I wanna try to connect my arduino to ceck all but before installing a generic firmware (Merlin???) without the right configuration, i wrote here asking for the right firmware and what to do with the dead arduino.
Arduino dead
-
zhangxueyou
- Posts: 1405
- Joined: Fri Feb 06, 2015 1:33 pm
Re: Arduino dead
Hi, matt813
You can refer to this page to upload the firmware:
http://www.geeetech.com/forum/viewtopic ... 20&t=16253
But you have to upload our firmware, which has difference from the firmware online.
You can refer to this page to upload the firmware:
http://www.geeetech.com/forum/viewtopic ... 20&t=16253
But you have to upload our firmware, which has difference from the firmware online.