Print Offsets

[Kimbleos]

I3 M201 printer. The print starts and lays down the first layer then lays down another layer about a quarter of and in to the front of the first. So it looks like it started over about a quarter of an inch in front of the first. Have rechecked all settings numerous times, nothing seems to work.

[Mark]

seems like the motors are skipping steps, how's the driver voltage? is it proper? you can check it according to this link:
http://www.geeetech.com/forum/viewtopic ... 17&t=17038

[Kimbleos]

The voltage for all axis were at about .57v. Put them to 1.0v and that fixed that problem. Should the extruder motors be set to .87v-1.2v also?

[Mark]

yes, set all of them to about 1.0V, expecially the Z axis and extruder motors, they need more power to work properly.