Printer: Prusa I3 Pro b
When I disconnected the wires from the thermistors of the hot bed and the extruder one (on the gt2560), while I had the printer turned on, I saw a small spark in the circuit and smoke began to flow. I turned it off quickly.
Now the lcd does not turn on and I do not know if I have burned anything else.
Please tell me what I can do.
Sorry for my bad English, I'm translating this with the google translate
Help please
Re: Help please
Hi,Could you show some pictures of the control board when power is on?I wanna know which parts of the board are burned.
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-
AkiAcevedo
- Posts: 2
- Joined: Sun Jun 11, 2017 5:40 am
Re: Help please
m2303adn was burned,
It is clear that this component is burnt
It is clear that this component is burnt
Re: Help please
In this case,you can contact your seller who sell you this printer about it.
-Keep your mind and try to test it.
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!