Conection problem
Conection problem
What can I do when the printer is maybe conected with the software but I can t controll the printer , it doesn t run the command
Re: Conection problem
Hi
I did not understand your question.
So I will ask.
Not sure if communication with the printer is activated
I did not understand your question.
So I will ask.
Not sure if communication with the printer is activated
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Re: Conection problem
Have you set the baud rate to 250000/256000?
Re: Conection problem
How is it going on?Tiefes wrote: Mon Sep 03, 2018 9:54 pm What can I do when the printer is maybe conected with the software but I can t controll the printer , it doesn t run the command
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!