Page 2 of 3
Re: Extruder motor not turning !
Posted: Fri Jun 12, 2015 12:00 pm
by zhangxueyou
Can you control the extruder by LCD?
Re: Extruder motor not turning !
Posted: Fri Jun 12, 2015 12:11 pm
by zuzumba123
i don't know how... and where must be plugged extruder on board?
Re: Extruder motor not turning !
Posted: Fri Jun 12, 2015 12:15 pm
by zuzumba123
yes i manually control from lcd but it not have any reaction
Re: Extruder motor not turning !
Posted: Fri Jun 12, 2015 1:35 pm
by zhangxueyou
Can you show me how you connect the motor to mainboard? Please take a photo of mainbaord.
Re: Extruder motor not turning !
Posted: Fri Jun 12, 2015 4:48 pm
by zuzumba123
http://joxi.ru/Y2LpzPphzJgz26 but i try all combinations ...not work
Re: Extruder motor not turning !
Posted: Fri Jun 12, 2015 5:54 pm
by zuzumba123
http://joxi.ru/gmv6py6uDbWWma I tried every combination ( i think ) but not work
Re: Extruder motor not turning !
Posted: Fri Jun 12, 2015 10:27 pm
by zuzumba123
What is the extruder pins in firmware?
Re: Extruder motor not turning !
Posted: Sat Jun 13, 2015 12:27 am
by zuzumba123
send to me scheme like please
http://vk.com/doc270172689_399713223?ha ... d050637343 ((( or my gt2560 is defective?
Re: Extruder motor not turning !
Posted: Sat Jun 13, 2015 8:41 am
by zhangxueyou
What's the status of the switches under motor driver? What type is the motor driver?
Re: Extruder motor not turning !
Posted: Sat Jun 13, 2015 2:31 pm
by zuzumba123
Driver pins are mon. All is ok . Motor driver geeetech t/0042. I dont know. It is standart geeetech i3