Page 3 of 3
Re: i need help with Heatbed MK2a
Posted: Thu Aug 06, 2015 2:18 am
by gastipincha
i have mesured that , its 11.9 volts both...what should i do next ?
Re: i need help with Heatbed MK2a
Posted: Sat Aug 08, 2015 6:18 am
by gastipincha
i have mesured that , its 11.9 volts both...what should i do next ???
i would apreciate if someone could help me tx
Re: i need help with Heatbed MK2a
Posted: Thu Aug 13, 2015 11:32 am
by gastipincha
hello again... i have mesured that , its 11.9 volts both...what should i do next ???
I have an other problem, the Z axis cant move smoothly , it goes up but makes a lot of noice , but does not go down...
please can SOMEONE help me ? How Should i fix this problem....
this is its very frustrating
i would apreciate if someone could help me PLEASE cause i don't have any answers yet...
if someone can take some time to answer me i will appreciate it
Re: i need help with Heatbed MK2a
Posted: Thu Aug 13, 2015 1:41 pm
by Mark
Is your heatbed work now? If not ,Please check if somewhere of the wire are connected. If so, the current will not go through thermistor.