Page 1 of 1
Machine Customization
Posted: Tue Apr 14, 2015 2:37 pm
by midiman310
Don't know if this is the right place for this topic but, if anyone's interested and wants to reconfigure their banner screen on the LCD, very easily done.
- IMG_3733.jpg (137.16 KiB) Viewed 9986 times
Re: Machine Customization
Posted: Wed Apr 15, 2015 11:11 am
by zhangxueyou
Wow, I am so curious that how did you do that? Can you take a picture with other angles?
Re: Machine Customization
Posted: Fri Apr 17, 2015 3:54 pm
by midiman310
Ok, here's a shot straight on.
- IMG_3735.jpg (126.37 KiB) Viewed 9949 times
Re: Machine Customization
Posted: Mon Apr 20, 2015 11:54 am
by zhangxueyou
How about the back side？
Re: Machine Customization
Posted: Mon Apr 20, 2015 2:26 pm
by midiman310
Zhangxueyou- This is the last picture I have of close to the back of the printer with the stock controller (LCD2004). I have since installed the Geeetech 12864 Graphics controller.
- IMG_3726.jpg (65.88 KiB) Viewed 9945 times
It was very easy to install and configure. Here's a picture of it.
- IMG_3741.jpg (120.64 KiB) Viewed 9945 times
Things were a few minor issues which were easily corrected. I changed the jumper to leave the LCD on all the time. I enabled and changed the tone of the "beeping" so it would give me positive acknowledgment without sounding annoying. Also changed the direction rotation of the selector knob and encoder amount of pulses per step to get 1 to 1 click with menu movement. There should be a way to control the LCD contrast via the on screen menu. I'll have to revisit that later.
By the way, would you happen to know what version of Marlin Firmware Geeetech is using for the Acryllic I3 Pro?
Re: Machine Customization
Posted: Mon Apr 20, 2015 2:50 pm
by zhangxueyou
No version for Marlin firmware, because it's open source.
Re: Machine Customization
Posted: Mon Apr 20, 2015 4:37 pm
by midiman310
zhangxueyou wrote:No version for Marlin firmware, because it's open source.
Ah, yes, so is it Marlin_V1 or Marlin_Development? Because there are subtle differences between the 2.
Re: Machine Customization
Posted: Mon Apr 20, 2015 4:58 pm
by zhangxueyou
midiman310 wrote:zhangxueyou wrote:No version for Marlin firmware, because it's open source.
Ah, yes, so is it Marlin_V1 or Marlin_Development? Because there are subtle differences between the 2.
You can call it whatever.