Page 1 of 1

How to install the MK8 Dual Extruder?

Posted: Mon May 04, 2015 10:45 pm
by vad7
Printer - Acrylic I3.
This MK8 Dual extruder (http://www.geeetech.com/mk8-dual-extruder-p-921.html) does not fit onto the dual extruder bracket for I3C printer.

Re: How to install the MK8 Dual Extruder?

Posted: Tue May 05, 2015 9:16 am
by zhangxueyou
Could you please take some pictures, show me which part not fit?
We can guarantee that the extruder holder and extruder bracket fit the dual extruder.

Re: How to install the MK8 Dual Extruder?

Posted: Tue May 05, 2015 1:42 pm
by vad7
Differs.jpg
Differs.jpg (164.42 KiB) Viewed 16053 times

Re: How to install the MK8 Dual Extruder?

Posted: Tue May 05, 2015 2:35 pm
by zhangxueyou
Unload the 2 fans and gold metal, mount the fan to the holes highlighted in the picture.
QQ截图20150505143335.png
QQ截图20150505143335.png (229.37 KiB) Viewed 16051 times

Re: How to install the MK8 Dual Extruder?

Posted: Tue May 05, 2015 2:52 pm
by vad7
If I remove these parts the cooling will be worse.

Re: How to install the MK8 Dual Extruder?

Posted: Tue May 05, 2015 3:02 pm
by zhangxueyou
I think it's not that worse. When we tested dual extruder, we use only one fan, and so far it's been working well for several months.

Re: How to install the MK8 Dual Extruder?

Posted: Tue May 05, 2015 3:12 pm
by vad7
Ok, Why you sell it with two heatsinks and fans?

Re: How to install the MK8 Dual Extruder?

Posted: Tue May 05, 2015 3:22 pm
by zhangxueyou
Did you buy it seperately?
Generally, when you buy a whole printer, we send dual extruder with 2 fans in case of one is dead, but no heatsinks.

Re: How to install the MK8 Dual Extruder?

Posted: Tue May 05, 2015 11:23 pm
by vad7
I buy MK8 Dual extruder (link - http://www.geeetech.com/mk8-dual-extruder-p-921.html) and don't understand why you send me extruder with two heatsinks + fans if I need to remove them.

Re: How to install the MK8 Dual Extruder?

Posted: Wed May 06, 2015 9:17 am
by zhangxueyou
MK8 Dual Extruder not only fits i3 C printer, but also fits some other brands of printer.Considering this, we add heatsinks when we sell it separately. After all, 3D printer is a DIY product, we not only consider for people who use our printer, but also people who use other printers.
But when we sell a whole printer with dual extruder, we remove the heatsink and leave only 1 fan, because we've tested one fan without heatsink and has no problem.
Sorry for wasting your time on removing the heatsinks.