Print Jobs not sticking to surface of heat bed

[ric chin]

My Prusa 3i pro c is now printing like a champ on both heads..thanks to the new firmware.

I have a new issue now.

Print jobs not staying put till they are done...

I have tried increasing the bed heat to max 135c but it still gets knocked off.
Any suggestions on how to make jobs stick till they are done?

[Sherry]

My Prusa 3i pro c is now printing like a champ on both heads..thanks to the new firmware.

I have a new issue now.

Print jobs not staying put till they are done...

I have tried increasing the bed heat to max 135c but it still gets knocked off.
Any suggestions on how to make jobs stick till they are done?

you could check the gap between nozzle and hot bed.the best distance is 0.1mm