Print Jobs not sticking to surface of heat bed
Posted: Mon Jul 20, 2015 2:34 pm
My Prusa 3i pro c is now printing like a champ on both heads..thanks to the new firmware. 
I have a new issue now.
Print jobs not staying put till they are done...
I have tried increasing the bed heat to max 135c but it still gets knocked off.
Any suggestions on how to make jobs stick till they are done?
I have a new issue now.
Print jobs not staying put till they are done...
I have tried increasing the bed heat to max 135c but it still gets knocked off.
Any suggestions on how to make jobs stick till they are done?