Page 1 of 1
Prints not center on heated bed and how to Sd card printing
Posted: Mon Oct 12, 2015 5:31 am
by 3d_daw
Hello.
After so many hours spending calibration and many problem encountered I finally able to print ... I have a Delta Restock Mini G2s dual extruder bought last August and haven't use the printer...now, I've got another issue...
1. How do I center the prints on my G2s ... As it appear the print is more towards near the LCD panel
2. I was looking at tutorial how to use or printing using SD card...but not found any topic here and no instructions found.can you provide any step/ guides
Thanks for the help in advance, please Help.
Re: Prints not center on heated bed and how to Sd card print
Posted: Mon Oct 12, 2015 10:58 pm
by Mark
If you use repetier 1.5.6, you can slice the object with slic3r, and generate the .gcode file for SD card printing here:
- QQ截图20151012225110.jpg (135.92 KiB) Viewed 7602 times
"How do I center the prints on my G2s ... "
and how do you set your printer setttings?
- 2.jpg (234.93 KiB) Viewed 7602 times
- 1.jpg (68.04 KiB) Viewed 7602 times
Re: Prints not center on heated bed and how to Sd card print
Posted: Tue Oct 13, 2015 12:38 pm
by 3d_daw
Hi Mark,
Thanks for the help... I followed your instructions and settings ... it's still off by at least 10mm ...
Not sure we're to adjust these... .I marked the center (+) and the center for printing was (dot) ...anyway I'm good with this rather than before 20mm but it would be nice if it was centered...
I will check the Sd card printing and will let you know.. Thanks again
Re: Prints not center on heated bed and how to Sd card print
Posted: Tue Oct 13, 2015 4:00 pm
by Mark
wait, let me see, and have you set the settings here for dual extruders?
you can refer to the link here to set them:
http://www.geeetech.com/forum/viewtopic ... 13&t=17064
Re: Prints not center on heated bed and how to Sd card print
Posted: Wed Oct 14, 2015 2:16 pm
by 3d_daw
It finally work...hurray!!! It was centered
I guess you have to update the "wiki instruction " with these "Y off set " settings need to adjust when you have G2s ... So every user /buyer won't have difficulty finding information such like these.
Again, thank you for the help!
Re: Prints not center on heated bed and how to Sd card print
Posted: Wed Oct 14, 2015 3:46 pm
by Mark
Will update it later sometime, thanks for yor advice!