second extruder to m201

[syossi2]

hi mark

I have the new m201 ver.b
can I add to it second extruder so one extruder will be with the mixer and second extruder will be just like second one
this way this printer will be very powerful and with lot more option

I see that the board have connectors to second extruder
and maybe I think also plenty space on the rods to add one more extruder

what do you say?

thanks
Yossi

[Mark]

we have no such firmware for this, but we have another firmware for you to upgrade your M201 to a dual extruder printer, check out this link:
http://www.geeetech.com/forum/viewtopic ... 13&t=17594

[syossi2]

hi
yes i see it but i want also use the mixer

i thing i dont need firmware for this no?

just third extruder to connect to the pcb that alrady have open connector for it
and second hotend that also that have on the board open connector

and then control it via the simplfly3d or other slicer like other extruder

no???


thanks
yossi

[Mark]

No, I think you still need to set the extruder number to 3 in the firmware or you can not use it.

[syossi2]

Ok
So can engineering add third one to the firmwaere?
I willing to pay for this service

Yossi