Page 1 of 1

min temp error

Posted: Mon Apr 18, 2016 8:49 am
by kevink18
I just got my GS2pro put together installed firmware and when I try to connect is shuts down for min temp error. All temps are showing 0 deg tested board by shorting out pins to test for max temp like in another post they still read 0 deg. could this be a firmware issue or a bad board

Re: min temp error

Posted: Tue Apr 19, 2016 6:11 pm
by Mark
Is there a bad soldering between those pins of the thermistor connectors? Or did you try to reinstall the firmware?