Page 1 of 1
Extruder min temp error with new complete extruder
Posted: Tue Sep 27, 2016 6:16 pm
by Brunetti91
I shorted out my hot end and I bought a new complete extruder and now when I plug it up I get a min temp error
Re: Extruder min temp error with new complete extruder
Posted: Wed Sep 28, 2016 2:03 pm
by Toy
This means your thermistor is open circuit, please check this part, see if there's a poor contact
- 20160928140034.png (833.72 KiB) Viewed 5163 times
Re: Extruder min temp error with new complete extruder
Posted: Wed Sep 28, 2016 6:22 pm
by Brunetti91
I will check today thank you!