Page 1 of 1

E180 CURA slicer profile

Posted: Sun Dec 31, 2017 2:51 am
by Bpz53
Hello,

Is there somebody who has tested CURA (or another software like REPETIER or SIMPLIFY 3D, ..) with the E180 printer ? If yes, could you post the E180 profile ? This question because I meet too much bugs with EASYPRINT3D.

All the best

Bernard

Re: E180 CURA slicer profile

Posted: Tue Jan 02, 2018 6:40 pm
by William
Happy new year!
I use Repetier-Host for slicing mostly.It can be printed very well.

Re: E180 CURA slicer profile

Posted: Thu Feb 15, 2018 11:32 am
by howchoo
Hi William,

Can you post screenshots of the rest of your settings? I have a Mac and thus can't even load the EasyPrint 3D software, so I'm using Cura. Also open to using Repetier-Host if need be.

Thanks!
Zach

Re: E180 CURA slicer profile

Posted: Fri Feb 16, 2018 11:24 am
by William
Personal Cura profiles for E180 have been uploaded to the forum, you can download

Re: E180 CURA slicer profile

Posted: Sat Mar 03, 2018 6:33 pm
by sectorbob