Page 1 of 1
What causes this problem.
Posted: Sun Jun 02, 2019 6:56 am
by choadicus
Why? This is a dual printer and were only printing one color. It printed great for most of it then went stupid
Re: What causes this problem.
Posted: Mon Jun 03, 2019 5:05 am
by choadicus
We got it. Its a duel feed extruder. We only had filament on one side. The top of the dog uses the second feed.
Re: What causes this problem.
Posted: Thu Jun 06, 2019 4:41 am
by Chub
Perfect timing on this question. I just printed the dog last night and had the same issue when I took it off. Couldn't figure out what happened. Yup, I only loaded extruder 1.
Re: What causes this problem.
Posted: Mon Jun 17, 2019 12:13 am
by Chub
How do I get filament down to the hotend of an A10M? The display only knows e0. When I do Change filament it does eo, nothing about e1.