I bought an A30 one Year ago. I didn´t print a lot. I lost my interest because of all these errors…
First the leveling just did not work, after a Firmware update I was not able to install the NPN sensor.
I watched all the Videos on YouTube tried 2mm - 8mm distance to the heatbed. I got the issue that the red light lights up, but the Printer just crashes into the heatbed… Today a half year later I tried it again an the Printer started to autolevel before printing but in the middle he crashed again. After a factory reset he again does detect the heatbed (red light) but just do not stop.
mobdro kodi
I really have no clue why and I would love to destroy this printer because I have not more Patience....
I hope some of you can help me.
Greetings.