Hello again.
At melzi board no.1 i still dont get x and e motor running, i gave this up now.
At another board i now got all motors working but i still get wrong temperatures.
I compared the getech melzi with another melzi from UK and found out that there is diffrent hardware on the getech-melzi.
The ...
Search found 3 matches
- Thu Dec 05, 2013 8:59 pm
- Forum: Control Board
- Topic: Melzi Ardentissimo Failure
- Replies: 13
- Views: 34914
- Wed Dec 04, 2013 5:53 pm
- Forum: Control Board
- Topic: Melzi Ardentissimo Failure
- Replies: 13
- Views: 34914
Re: Melzi Ardentissimo Failure
Ok, y and z are now running at 1/16 step, but x and e still don't run and the temperature is still wrong.
Any ideas for this?
thanks
Any ideas for this?
thanks
- Wed Dec 04, 2013 7:01 am
- Forum: Control Board
- Topic: Melzi Ardentissimo Failure
- Replies: 13
- Views: 34914
Re: Melzi Ardentissimo Failure
Hello, I had same trouble with this board.
I now have uploaded the monomendel/huxley marlin firmware of reprappro.
this works when sd support is disabled.
But now i have other problems:
x axis does not work
e axis does not work
temperature is 45 deg at room temperature of 25 deg
the working stepper ...
I now have uploaded the monomendel/huxley marlin firmware of reprappro.
this works when sd support is disabled.
But now i have other problems:
x axis does not work
e axis does not work
temperature is 45 deg at room temperature of 25 deg
the working stepper ...