Melzi Ardentissimo Failure

[heimfabrikant]

Ok, y and z are now running at 1/16 step, but x and e still don't run and the temperature is still wrong.
Any ideas for this?

thanks

[techsupport]

hi
guys

you can change the x motor ,and observe the motor rotation

[heimfabrikant]

Hello again.
At melzi board no.1 i still dont get x and e motor running, i gave this up now.
At another board i now got all motors working but i still get wrong temperatures.
I compared the getech melzi with another melzi from UK and found out that there is diffrent hardware on the getech-melzi.
The Parts at "R4" and "R5" are "103", on the melzi from uk these parts are "472".
Does anybody know how to change this in firmware?

[techsupport]

hi
guys

you can download firmware from our WIKI website.