Good day,
I purchased an I3PC, and have found that the bearing clamps on the X axis have cracked. These are obviously printed parts, perhaps the previous owner has swapped them out and printed using PLA.
Has anyone had experience with replacing them, and what filament did you use to do so? Do you have a link to the STL's that you used? As there are a few on thingiverse I am not 100% sure which are the right ones.
X-Carriage Replacement
Re: X-Carriage Replacement
Hi, you need to loosen the belt and then install the belt clip and adjust the belt to a moderate degree of tightness.
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-
Mr.Hotwire
- Posts: 21
- Joined: Mon Jun 24, 2019 9:16 am
Re: X-Carriage Replacement
Hi 'Mr.Hotwire'
How about replacing with these ?
It has to be a better solution ?
https://www.geeetech.com/upgraded-metal ... p-970.html
Gerry
How about replacing with these ?
It has to be a better solution ?
https://www.geeetech.com/upgraded-metal ... p-970.html
Gerry
-
Mr.Hotwire
- Posts: 21
- Joined: Mon Jun 24, 2019 9:16 am
Re: X-Carriage Replacement
Good idea, I will look into it. I have printed off a set, But I will be doing some modifications to them to help make them more stable.