Brand New Printer - motor/board i/o problem.

[KnowledgeIsPower]

So I swapped out the end stops and all the end stops in question are working correctly. The Z axis is still only rotating 10 rotations on the Home and stopping. During the rotations the end stop doesn't stop it even when switched to a new one. The one in question works on the new axis fine.

Dan

[KnowledgeIsPower]

Also it's still not going upwards still, after changing the direction from false to true it will climb just like it descended but only after a firmware change..

[KnowledgeIsPower]

Hi,

I bought a volt meter and I've checked all the stepper driver voltages and they are all set to .98v and the Z axis driver is set to 1v. However there is no change in the z axis behavior. It it still able to rotate in one direction only for 10 turns and stops.
Do I have a board issue? What do you think I should do next?

Thanks,
Dan

[KnowledgeIsPower]

I've noticed that on the main interface it says Z endstop hit when I press the Z axis in the up direction. I unplugged all the end stops to see if it would move upward in that case and it's still not moving. Still goes down 10 rotations tho..

Is there a bit of firmware I should check to see if the z axis is deactivated or something odd? if all the end stops are unplugged from the board why would it say it's reading it? Software or hard ware?

Dan

[William]

Hi,Dan
Sorry for my late reply...
How is everything going now?