Problem with 8mm and bearing x and y axis

attiliopiccolo · Post by **attiliopiccolo** » Wed Apr 05, 2017 3:33 am

Good mooring,
i have just finish my Acrilic prusa I3.

During the mount I check just a problem, two 8mm shaft don't work well in the bearing.
At the end of assembled the printer don't work well; the motors don't have the power to move the axis, also with had it not real free.

Post by **William** » Fri Apr 07, 2017 4:09 pm

Hi,you can check this post viewtopic.php?f=17&t=17038.

Geeetech

Problem with 8mm and bearing x and y axis

Problem with 8mm and bearing x and y axis

Re: Problem with 8mm and bearing x and y axis