I purchased a v6 hotend, and printed the mounting parts, and installed it. I could not get it to print correctly no matter what the settings. The V6 has a different thermistor, and from what I have read firmware has to be changed manually in order to set it up correctly. Has anyone done this on an A30?
How is this accomplished.
Forr now the original hot end is back on there.
Installing an E3V6 hotend?
Re: Installing an E3V6 hotend?
Hello.
I have another suggestion.
Did you think about replacing the thermistor
It could be much easier. This electronic component is not expensive.
I have another suggestion.
Did you think about replacing the thermistor
It could be much easier. This electronic component is not expensive.
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Re: Installing an E3V6 hotend?
The geeetech thermistor is too big for the V6 hole to fit.
Re: Installing an E3V6 hotend?
I´ve manage to use a original V6 with no problem with latest fw
Re: Installing an E3V6 hotend?
so far i use an trianglelab v6 clone, and a titan aero clone without any trouble, shure u will need socks bcs the pid tuning isnt made for that but havent anny other trouble
Re: Installing an E3V6 hotend?
Ist there anywhere a documentation
..? I would like to do this step.
..? I would like to do this step.Re: Installing an E3V6 hotend?
I think with the original 