Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
http://forum.geeetech.com/
ya sir we did try other things but its not workingBR365 wrote: Mon May 13, 2019 4:02 pm Hi Vert,
I guess, the only possible solution is to remove these disks.
E-Steps changed to 422 (Calibration done), ...
mywegmansconnect
No new result depending the stringing.
IMG_20190512_153329.jpg
Great informationBR365 wrote: Thu Apr 25, 2019 1:23 pmHello William,William wrote: Thu Apr 25, 2019 9:36 am Does the extruder working temperature achieve Preset temperature？
I don't have a thermometer, therefore, I didn't check this. The Dog was printed with 205°C:
This looks very good, I think.
See Discussion here: http://www.geeetech.com/forum/viewtopic ... 08&t=68468 mywegmansconnect.club
Thanks,
Moritz
Great Thanks for sharingTomyuan wrote: Thu Apr 25, 2019 1:57 pm If you want to calibrate your estep.
Refer to this vid：
https://www.youtube.com/watch?v=X3A9Ir2SreI
My estep is 457
