Geeetech

That's it! I added a semicolon at the beginning of both lines and now my temp settings are used. Thanks!

Hi,

I have set up the temperatures to 185°C for PLA and 70°C for bed, but whenever I start a print PLA temp jumps to 200°C and bed temp goes down to 60°C.

My exact temperature settings in Cura are as follows:

Print Setup:
- Default Printing Temperature: 185°C
- Printing Temperature: 185°C ...

Thanks for the very detailed explanation aarli. I think I actually managed to level the bed now (test print in progress), but that will be very useful if I need to make more adjustments. Which might be sooner than later as I'm now facing another issue: the bed is very off-center. About 1 cm on the X ...

I managed to remove the waving by adjusting the wheels (it took me many hours though), so that problem is solved. I still can't manage to print anything but I suppose it's just about settings and fine tuning now.

Thanks again Ben!

Thanks a lot Ben!

I was wondering why the spacers on the right where a different shape. I unfortunately can't try that now as I lack the tools (and I'm kind of disappointed they are not provided, considering that the unit came with a 18 mm flat wrench I can't find any use for) but I'll try to buy ...

Hi,

I'm new to 3D printing. I received my A10 a week ago and I haven't managed to print anything useful as the first layer won't stick to the bed.

I have tried different settings (see below) but I think the problem it that the bed is "wavy" on the Y axis: when I move the bed from front to back ...