Repetier-Host setting on ABS print

[animetown9]

Hi

Does anyone here have a good setting for Repetier-Host ABS printing with
Acrylic Geeetech I3 pro and Sanguinololu 1.3a.

[zhangxueyou]

Please tell me the filament diameter and nozzle diameter.

[animetown9]

Hi

Filament 1.75 , nozzle 0.3mm

ABS filament.

[zhangxueyou]

slicer settings(1.75-0.3).zip

(715.7 KiB) Downloaded 1019 times

[johnz]

How about setting for 1.75 and 0.4 ABS?? Thanks

[Mark]

you can use the settings above too, just need to change the diameter of the nozlle to 0.4mm.

QQ截图20151111175429.jpg (153.12 KiB) Viewed 14121 times

QQ截图20151111175551.jpg (281.52 KiB) Viewed 14121 times

Also you can refer to the link here to use the repetier host:
http://www.repetier.com/#documantation

[Derekchong]

I followed these setting but the print out is horrible. Any good advise?