Multi Color Printing Problem

[rmrodrigues]

Hi There,
I'm trying to print a key holder example made by me but the second extruder is printing out of the correct location.

Please see the attached photo.


When I use Slic3r the extruder print at same time and side by side. This gcode was generated with CURA and the result is above.

Any suggestion?

Best,
RMRodrigues.

[Mark]

the photo is broken...

[rmrodrigues]

Here is it:



Thanks Mark.

[Mark]

oh I see you use cura, sorry I haven't used it before...

[rmrodrigues]

Hi Mark,
I've used CURA as an alternative to Slic3r.
There is a guide to do that on Slic3r?

Thanks.

[rmrodrigues]

Mark I think that my problem is due to a bad offset. What you think about that?

[Mark]

I think you can refer to this link to check the settings:
http://www.geeetech.com/wiki/index.php/ ... _extruders