nozzle diameter

[andy65]

Hi i have the prusa i3 printer with mk8 extruder how do you work out what the nozzle diameter is.i guess it is 0.4 mm as default but on the extruder itself is a label marked
MK 8 Extruder 2-0.3mm (forward) does this mean my nozzle is 0.3 mm not 0.4 mm All i can see on the nozzle itself is the # 2 i have set everything to 0.4 in repetier but still dont get enough filament flow comes out thin.What should be the average speed rate when printing with pla.Thanks Andy

[William]

Hi i have the prusa i3 printer with mk8 extruder how do you work out what the nozzle diameter is.i guess it is 0.4 mm as default but on the extruder itself is a label marked
MK 8 Extruder 2-0.3mm (forward) does this mean my nozzle is 0.3 mm not 0.4 mm All i can see on the nozzle itself is the # 2 i have set everything to 0.4 in repetier but still dont get enough filament flow comes out thin.What should be the average speed rate when printing with pla.Thanks Andy

Hi,Andy
1.I think you can find the nozzle size in your order info or you can find it directly from your nozzle:

QQ截图20160822151347.jpg (28.37 KiB) Viewed 9219 times

2.About the flowing rate,you can increase this value to 1-1.1 in your slicer settings:

QQ截图20160822151702.jpg (41.97 KiB) Viewed 9219 times

Or maybe it's your extruder caused this,check the following tips:
http://www.geeetech.com/forum/viewtopic ... 19&t=17097