temperature problem when printing

Rush68 · Post by **Rush68** » Tue Apr 30, 2019 10:42 pm

Hello everyone, I have a problem when I print.
I bought a Delta Rostock mini G2s pro, it starts printing very well and I already printed several pieces, but now it gives me an error of maximum temperature reached at a certain moment of the printing, which could be, I use the program repetier-host v2 .1.3

Post by **_kaktus_** » Tue Apr 30, 2019 11:53 pm

Hello.

Have you tried to lower the temperature by e.g. 5°C?
Repetier Host draws graphs for temperature, you can analyze what happens over time.

Rush68 · Post by **Rush68** » Wed May 01, 2019 12:40 am

ok, thanks, I'll try

Rush68 · Post by **Rush68** » Wed May 01, 2019 3:20 am

decreased 8 degrees centigrade and I still have the same problem

Post by **_kaktus_** » Wed May 01, 2019 3:53 am

Hi.

Have you seen the temperature chart in RepetierHost?
Can you show the screen

Rush68 · Post by **Rush68** » Thu May 02, 2019 11:11 pm

hi here is the screenshot of the problem

: problema temperatura.jpg (278.38 KiB) Viewed 12825 times

Rush68 · Post by **Rush68** » Tue Jun 11, 2019 11:18 am

Hello everyone, thanks to everyone, it is noted that in this forum is supported, I already solved it were thermistors, thanks for your help

Geeetech

temperature problem when printing

temperature problem when printing

Re: temperature problem when printing

Re: temperature problem when printing

Re: temperature problem when printing

Re: temperature problem when printing

Re: temperature problem when printing

Re: temperature problem when printing