Auto bed leveling on A30 connection.

[alexy34]

Hi everyone,
I want to install a 3DTouch auto bed leveling sensor on my A30.
Did these pins on the back of extruder are for connection ? P.S. see picture.
Anyone has a picture how these plugs are connected ?
Do i need a firmware update ? or just connect the auto leveling sensor and do the setup on the lcd screen ?
Thanks

[William]

Hi，this is the connection diagram:

3d touch 接法.png (398.84 KiB) Viewed 8296 times

you need to change the firmware and update.
You can refer to this:
http://www.geeetech.com/wiki/index.php/ ... ing_Sensor

[alexy34]

Hi William
I took a look at marlin arduino, it's complicated, I'm going to drop the auto leveling because I don't want to have a problem with the firmware again.
Thanks

[William]

Hi, according to the manual step by step operation is not complicated. 3Dtouch can automatically level, which is more convenient for future use.

[alexy34]

Hi William
I did the 4 steps according to the manual, but when I checked the coding it gave me an error.
You can see the pictures, I did the same thing as the manual.
Where is the problem ?
Thanks

[William]

Sorry, I just confirmed that there is no need to change the firmware, this firmware supports 3dtouch, you can just connect the auto-leveling sensor and do the setup on the LCD screen.

[alexy34]

Hi William
Are you sure i don't need to change or upgrade firmware ?
Just I need to connect the auto-leveling sensor and do the setup on the LCD screen ?
Thanks

[William]

yes.

[alexy34]

Thank you

[William]

you are welcome!